Instructions stones tattoo
In summary our temporary tattoos are carried out in three steps:
1 - Tattoo Ink stone
Place the stone on the ink and press lightly for a few seconds over the entire surface of the stone.
Remove the stone vertically and make sure the ground is completely covered with ink.
2 - Apply on the skin to the desired location
Then ask it on the part of the body tattoo without much support .
For stones larger sizes must apply the tattoo immediately ensuring that all parts of the ground were well affected skin .
Make a gesture from the rear towards the front , for example.
3 - Remove then gently
Carefully remove the stone and wait a few seconds until the tattoo is dry .
Tattoos disappear after few days.
To erase the tattoo use baby oil or makeup remover . After the shower dab the skin.
All our products are for external use . Do not use in the eye area and use by children should be supervised by an adult
Inking, glitter, UV liner is used in the same way as conventional products.
They are invisible during the day and light up at night with the presence of UV lamps. Lamps found in most trendy club.
To prepare your UV tattoos you can get our UV lamps.
Reloading the ink
The ink pad recharges in 4 steps :
Do not pour the whole bottle of ink in the ink.
- Open the ink and remove the white foam.
- Pour approximately one quarter of the ink in the vacuum flask.
- Replace the foam in the ink, smooth above.
- Pour about half of the flask through the foam.
Keep the remaining quarter when your ink starts to dry.